
Gravel Driveways in Almont, MI
Almont is a village on M-53 fifteen minutes from Capac, where new houses keep going up on split-off acreage. Elite Excavating cuts, bases and crowns the drive from the road to each house site, and fixes the old ones. Free on-site estimates: call George at (989) 702-2426.
- Free on-site estimates
- Owner-run by George
- Based in Capac, MI
Gravel driveways in Almont
A village with farm ground on every side
Almont has been here since the 1830s, and the village center still sits at the corner of Van Dyke and St. Clair Street. It is growing again, up about six percent between the 2010 and 2020 censuses, and most of that growth is houses on acreage in Almont Township rather than lots in the village.
When a farm field is split and sold, the first thing the new owner needs is a way to get a truck to the building site. That is where most of George's Almont driveway work starts: a new drive on ground that was corn last year.
The first drive on a new split
A field has a foot or more of topsoil on it, and topsoil is the worst thing to build a drive on. It holds water and turns to mud under a loaded truck. George strips it off the drive line and saves it for the yard later, then cuts down to the clay-loam till underneath.
The base goes down in compacted lifts on that firm ground, wide enough for the concrete trucks and the lumber deliveries that are coming. The surface gets crowned so water runs to the ditches. A drive built this way carries the whole build without rutting, and it is still there when the house is done.
Van Dyke is MDOT, the rest is the road commission
M-53 runs through the middle of Almont, and it is a state trunkline. A new drive onto it needs a permit from MDOT. Everywhere else in the township, a new approach onto a county road goes through the Lapeer County Road Commission, which publishes its own standards for gravel approaches and takes applications online.
Inside the village, the streets belong to the Village of Almont, so ask the village about its own rules. He has worked with each office and tells you which one applies at the estimate. The guide on driveway and culvert permits in Michigan explains who issues what.
Base, crown and the clay underneath
The ground around Almont is loam over clay loam, somewhat poorly drained, with a water table that sits close to the surface from fall to spring. A drive on that ground lives or dies on whether water can get off it. George crowns the surface and keeps the ditches open so the base stays dry.
21AA or 22A crushed limestone is the standard material. It locks together under traffic and sheds water when it is crowned. The guide on how a gravel driveway gets built walks through the steps in order.
Soft spots and spring ruts on an older drive
Older drives around Almont tend to have one or two soft spots that go bad every spring. They sit where the base was thin or the ground was wet when the drive was built. Topping them with stone works until the next thaw.
George cuts the soft section out, re-bases it and ties it back into the rest of the drive. He does that once the spring weight restrictions have lifted. MDOT sets those on state roads and the Lapeer County Road Commission sets its own on county roads, and loaded gravel trucks are limited while they are on.
A price for the drive, and the pad to go with it
George comes out, walks the drive line with you and gives you one price with the stone, the hauling and the culvert in it. The estimate is free, and because he runs the machine himself, the drive gets built by the person who priced it.
On a new split the drive and the building pad are usually one visit. See pole barn pads in Lapeer County for that side of it. If an old barn is in the way, demolition in Almont can go first. The main driveway page has photos of finished work, and the Almont town page lists everything else he does there.

Gravel Driveways
New gravel drives cut, based and crowned, plus potholes, washboard, spring ruts and soft spots repaired.
See the serviceTalk to George(989) 702-2426
Call George about a drive in Almont. He walks it with you and gives you one price with the stone and the hauling in it.
Call nowWhat that covers
- New drives on acreage. Topsoil stripped, the base built on firm till, wide enough for the build traffic.
- Approaches and culverts. The culvert sized for the ditch and the approach built to the road commission's standard.
- Soft spot repair. Bad sections cut out, re-based and tied back into the drive.
- Crowning and regrading. Flat, worn drives reshaped so water runs to the ditches again.
Almont, MI
A village on M-53 fifteen minutes southwest of Capac, surrounded by Almont Township farms and acreage.
Town pageAlso in AlmontDemolition in Almont, MI
See the pageAlso in AlmontYard Drainage & French Drains in Almont, MI
See the pageThe serviceGravel Driveways
New gravel drives cut, based and crowned, plus potholes, washboard, spring ruts and soft spots repaired.
Main service pageAlmont and the towns nearby
The same driveway work runs up and down M-53. See gravel driveways in Imlay City for the farm drives north toward I-69, and gravel driveways in Romeo for the village and estate lots south across the Macomb County line. The Almont town page has the rest of his work in the village, and the Lapeer County driveway page covers the county as a whole.
You get George. Not a crew he sent.
You call
You call. George comes out and looks at the job with you, on the ground, rather than pricing it off a photograph.
A number first
You get one figure before anything starts, with the hauling and the grading in it.
He runs the machine
Then he shows up and runs the machine himself.
Ground left usable
Voids get filled and the ground is graded back so you can pour, build or seed.
Photos of his work.
These are photographs from actual jobs. See more recent work. Or read about the full gravel driveways service.



Questions people ask
Not seeing yours? Call (989) 702-2426 and ask George, or read the guides.
I just bought a split in Almont Township. What does the drive need?
The topsoil stripped off the drive line, a base built in compacted lifts on the firm ground underneath, and a crown so water runs to the ditches. Built that way it carries the concrete trucks and deliveries during the build without rutting.
Who issues the driveway permit in Almont?
On M-53 it is MDOT, because Van Dyke is a state trunkline. On a county road in Almont Township it is the Lapeer County Road Commission. Inside the village, ask the Village of Almont about its own streets. He tells you which one applies at the estimate.
Why does the same spot on my drive go soft every spring?
The base is thin there, or the ground was wet when the drive was built. When the frost comes out, that section has nothing firm under it. He cuts it out and re-bases it rather than topping it with stone, which only hides it until the next thaw.
Can you do the drive and the pole barn pad together?
Yes. On a new split they are usually one visit, since the same machine and the same stone are involved. He prices both at the walk-through so you have one figure.
How far is Almont from Capac?
About 14 miles, or fifteen minutes down M-53. Stone is hauled in from the yard and spread while the machine is on site, so it goes down where it belongs and gets compacted instead of sitting in a pile at the road.
Other work he takes on
Most jobs end up being two or three of these at once, and they get quoted together.
Gravel Driveways in other towns
Land Clearing & Site Prep
Trees, brush, scrub and stumps off the ground so it can be built on, farmed or mowed.
Learn moreDriveway Installation & Repair
New gravel drives cut, based and crowned; potholes, washboard and ruts fixed.
Learn moreDrainage
Standing water moved off yards and foundations, starting with the grade and adding pipe where needed.
Learn moreGrading & Land Leveling
Yards, lots and pads cut to a grade that sheds water.
Learn morePole Barn Pads
Pads cut, filled and compacted for pole barns, shops and garages.
Learn moreBrush Hogging & Forestry Mulching
Overgrown fields and fence lines mulched back to open ground.
Learn moreFree estimate in Almont.
Send the details and he will come out, walk the job with you and give you a number before anything starts. If it is easier to talk it through, call him.
Capac, Michigan · St. Clair, Lapeer and Macomb counties
Need gravel driveway work in Almont?
Call George. He walks the job with you and gives you a price before any work starts.
