Elite Excavating LLCEliteExcavating LLC
Aerial view of a gravel drive curving up to a house in the country
Asphalt Millings · Allenton

Asphalt Millings in Allenton, MI

Asphalt millings hauled, spread and graded on long drives, farm lanes and lots in Allenton, on a base that has been built to hold them.

  • Free on-site estimates
  • Owner-run by George
  • Based in Capac, MI

Free on-site estimate

Send it over and George calls you back.

Asphalt Millings · Allenton

Asphalt Millings in Allenton

They still need a base

Millings are a top layer, not a replacement for a base. The ground under them is stripped, built up and compacted first, and the surface is crowned so water sheds. Skip that and millings rut the same way gravel does.

Expect some softening on hot days while they are new, and edges that need occasional attention. The asphalt millings guide covers the trade-offs.

Driveways and pads on farm ground

A long drive across a field needs a firm base, a crown so water runs off both sides, and ditches or a culvert where the water has to cross. The same thinking applies to a pole barn pad: strip the topsoil, build up with compacted material and set the finished height above the ground around it. Read more in gravel driveways in St. Clair County and pole barn pads in St. Clair County.

Spring brings seasonal weight limits on many roads, which can hold up stone deliveries. Our guide to Michigan frost laws explains how they work, and the road commission posts the current notice.

Allenton at a glance

Allenton sits about five miles south of exit 176 on I-69, which makes it one of the closest communities to Elite's base in Capac. The Allenton ZIP code, 48002, serves all of Berlin Township, which means a 48002 address could be in Allenton itself, out by Berville, or on any of the farm roads in between.

Berlin Township covers a little over 37 square miles and had 3,115 residents at the 2020 census. Most of that ground is farm fields, fence rows and wooded lots rather than subdivisions. That shapes the work: long gravel drives back to a house or barn, fields that have gone to brush, and pads for outbuildings on land that has never been built on.

Stone or millings

Ask for stone and millings on the same estimate so the two can be compared fairly. Which one fits depends on the length of the run, what drives on it and how much dust matters.

Loads come in by truck, so spring weight limits on the roads can push a delivery back a few weeks. On county roads in St. Clair County those are set by the St. Clair County Road Commission.

A price before the work starts

George comes out to Allenton, walks the drive or the lot with you and gives you one price before any work starts. The estimate is free, and he runs the machine himself.

Allenton is a short drive south of Capac, about five miles south of exit 176 on I-69, so it is one of the nearest places Elite serves. The rest of the work in town is on the Allenton page, and the driveway installation & repair page covers the service across St. Clair, Lapeer and Macomb counties.

New stone driveway running up the side of a house
Main service page

Driveways: New drives cut in, tired ones brought back, and lots resurfaced — built on a proper base and crowned so the water runs off the edges.

How it goes

No mystery, no surprise invoice.

Walk the job

George comes out, looks at the ground with you and talks through what it actually needs.

A number before work starts

You get a price for the job in front of you, not a rate and a shrug.

The machine shows up

The equipment arrives when it was said it would, and the work runs start to finish.

Left clean

Ruts knocked down, ground graded, debris gone. The site is finished, not abandoned.

On the ground

Photos of his work.

Every photo here is from a real Elite Excavating job. See more recent work. Or read about the full driveway installation & repair service.

Farmhouse with a new gravel drive cut in across the lawn to the road
Gravel driveway curving past a lawn to a house and garage, shown from two angles
Track loader on a drive cut down to its base beside a house
Are asphalt millings the same as paving?

No. Millings pack into a firm surface but they are not hot asphalt. They cost less than paving and behave more like a hard gravel.

Do millings need a base?

Yes. They need a stripped, compacted base and a crown, the same as a gravel drive.

Can you put millings over my old gravel?

Often, once the old drive has been regraded and the soft spots rebuilt. George looks at the base before he prices it.

Does Elite Excavating do asphalt millings in Allenton?

Yes. Allenton is a short drive south of Capac, about five miles south of exit 176 on I-69, so it is one of the nearest places Elite serves. George looks at the job himself, gives you a price before any work starts and runs the machine.

More around Allenton

Other work he takes on.

Somewhere else? See the full service area or call (989) 702-2426.

Asphalt Millings in other towns

Free estimate

Free estimate in Allenton.

Send the details and he will come out, walk the job with you and give you a number before anything starts. If it is easier to talk it through, call him.

Capac, Michigan · St. Clair, Lapeer and Macomb counties

Free on-site estimate

Send it over and George calls you back.

Free estimate. A real number.

Call George. He walks the job with you and gives you a price before any work starts.

Call GeorgeFree Estimate