Elite Excavating LLCEliteExcavating LLC
Aerial view of a gravel drive curving up to a house in the country
Culvert Installation · Allenton

Culvert Installation in Allenton, MI

Driveway culverts in Allenton set in the road ditch at the size and depth the road agency calls for, with the approach built over them.

  • Free on-site estimates
  • Owner-run by George
  • Based in Capac, MI

Free on-site estimate

Send it over and George calls you back.

Culvert Installation · Allenton

Culvert Installation in Allenton

Culverts away from the road

Culverts are not only at the mailbox. A long drive that crosses a swale, or a lane across a low field, needs pipe where the water has to get from one side to the other. George sets those as part of the driveway and drainage work.

The culvert permit guide explains who decides what at the road.

The Belle River through Berlin Township

The Belle River runs through Berlin Township. The old settlement of Lesterville, at Belle River (Beardsley) Road and Sperry Road, began as a mill site on it, and its post office went by the name Belle River for a time. Property close to the river or its low ground can stay wet well into spring, and a lot that sheds water toward a house or a barn needs the grade fixed before anything else.

On most jobs the answer starts with shooting the grade and shaping the surface so water moves where it should. Pipe goes in only where the ground needs it. See drainage solutions. Work in the river, on its banks or in a stream channel is regulated by Michigan EGLE, so that gets checked with them first.

Who sets the size

The agency that owns the road controls the approach and the culvert in its ditch. On county roads in St. Clair County that is the St. Clair County Road Commission, and on state highways it is MDOT. They set the culvert size and placement, so ask before any pipe is bought.

A ditch that is really a county drain belongs to the St. Clair County Drain Commissioner, and work in a creek or stream is a question for EGLE. Confirm with each office before the job is scheduled. MISS DIG 811 comes first either way.

Allenton, Berville and the township roads

Berlin Township has more than one place name. Allenton grew from a crossroads first called Smith's Corners, founded around 1844 by an innkeeper who ran a stage line to Detroit, and it took its current name in 1910. Berville, in the south of the township, is about four and a half miles north of Armada. The township also once had a station on the Almont branch of the Pere Marquette Railway.

A new drive or culvert onto a county road in the township goes through the St. Clair County Road Commission, and a county drain away from the road goes through the St. Clair County Drain Commissioner. Check with the township as well before a pole barn or house goes up. Rules change, so confirm with each office before work starts.

Driveways and pads on farm ground

A long drive across a field needs a firm base, a crown so water runs off both sides, and ditches or a culvert where the water has to cross. The same thinking applies to a pole barn pad: strip the topsoil, build up with compacted material and set the finished height above the ground around it. Read more in gravel driveways in St. Clair County and pole barn pads in St. Clair County.

Spring brings seasonal weight limits on many roads, which can hold up stone deliveries. Our guide to Michigan frost laws explains how they work, and the road commission posts the current notice.

A price before the work starts

George comes out to Allenton, walks the ditch and the drive with you and gives you one price before any work starts. The estimate is free, and he runs the machine himself.

Allenton is a short drive south of Capac, about five miles south of exit 176 on I-69, so it is one of the nearest places Elite serves. The rest of the work in town is on the Allenton page, and the driveway installation & repair page covers the service across St. Clair, Lapeer and Macomb counties.

New stone driveway running up the side of a house
Main service page

Driveways: New drives cut in, tired ones brought back, and lots resurfaced — built on a proper base and crowned so the water runs off the edges.

How it goes

No mystery, no surprise invoice.

Walk the job

George comes out, looks at the ground with you and talks through what it actually needs.

A number before work starts

You get a price for the job in front of you, not a rate and a shrug.

The machine shows up

The equipment arrives when it was said it would, and the work runs start to finish.

Left clean

Ruts knocked down, ground graded, debris gone. The site is finished, not abandoned.

On the ground

Photos of his work.

Every photo here is from a real Elite Excavating job. See more recent work. Or read about the full driveway installation & repair service.

Yard and treeline after the ground was cleared and graded
Driveway rebuilt on a new stone base
Gravel drive running beside a white house to the back yard
Stone path and side drive between houses
Long gravel farm lane through fields, shown from two angles
Farm drive re-based and crowned
Who decides what size culvert I need?

The agency that owns the road. On county roads that is the county road agency, and on state highways it is MDOT. Ask them before buying pipe.

Can you do the culvert and the driveway together?

Yes. The approach, the culvert and the drive are normally built as one job.

Who handles a culvert under a new drive in Berlin Township?

For a county road, the St. Clair County Road Commission. George can talk through what is involved at the walk-through, but confirm the current requirements with the road commission before the drive is cut in.

Can you clear land near the Belle River in Berlin Township?

Land clearing and mulching on dry ground near the river is regular work. Anything in the river, on its banks or in a stream channel is for Michigan EGLE to approve first, so check with them before the job is scheduled.

Does Elite Excavating do culvert installation in Allenton?

Yes. Allenton is a short drive south of Capac, about five miles south of exit 176 on I-69, so it is one of the nearest places Elite serves. George looks at the job himself, gives you a price before any work starts and runs the machine.

More around Allenton

Other work he takes on.

Somewhere else? See the full service area or call (989) 702-2426.

Culvert Installation in other towns

Free estimate

Free estimate in Allenton.

Send the details and he will come out, walk the job with you and give you a number before anything starts. If it is easier to talk it through, call him.

Capac, Michigan · St. Clair, Lapeer and Macomb counties

Free on-site estimate

Send it over and George calls you back.

Free estimate. A real number.

Call George. He walks the job with you and gives you a price before any work starts.

Call GeorgeFree Estimate