Elite Excavating LLCEliteExcavating LLC
Aerial view of a gravel drive curving up to a house in the country
Culvert Installation · Almont

Culvert Installation in Almont, MI

Driveway culverts in Almont set in the road ditch at the size and depth the road agency calls for, with the approach built over them.

  • Free on-site estimates
  • Owner-run by George
  • Based in Capac, MI

Free on-site estimate

Send it over and George calls you back.

Culvert Installation · Almont

Culvert Installation in Almont

A culvert keeps the ditch flowing

Where a drive crosses a road ditch, the ditch has to keep carrying water. That means a culvert under the approach, set at the right depth and bedded so it does not crush, with the approach built over it and tied into the road without a lip.

A culvert that is too small, too high or silted shut backs water up into the yard and across the drive. Replacing a failed one is the same job as putting in a new one.

Van Dyke is MDOT, the rest is the road commission

M-53 runs through the middle of Almont, and it is a state trunkline. A new drive onto it needs a permit from MDOT. Everywhere else in the township, a new approach onto a county road goes through the Lapeer County Road Commission, which publishes its own standards for gravel approaches and takes applications online.

Inside the village, the streets belong to the Village of Almont, so ask the village about its own rules. He has worked with each office and tells you which one applies at the estimate. The guide on driveway and culvert permits in Michigan explains who issues what.

Who sets the size

The agency that owns the road controls the approach and the culvert in its ditch. On county roads in Lapeer County that is the Lapeer County Road Commission, and on state highways it is MDOT. They set the culvert size and placement, so ask before any pipe is bought.

A ditch that is really a county drain belongs to the Lapeer County Drain Commissioner, and work in a creek or stream is a question for EGLE. Confirm with each office before the job is scheduled. MISS DIG 811 comes first either way.

M-53 is a state highway

A new drive that opens onto M-53 is on a state highway, so the Michigan Department of Transportation has a say in the approach. On a county road it is the Lapeer County Road Commission. Check with the right office before the drive is cut in.

A price before the work starts

George comes out to Almont, walks the ditch and the drive with you and gives you one price before any work starts. The estimate is free, and he runs the machine himself.

Almont is about 14 miles from the yard in Capac. The rest of the work in town is on the Almont page, and the driveway installation & repair page covers the service across St. Clair, Lapeer and Macomb counties.

New stone driveway running up the side of a house
Main service page

Driveways: New drives cut in, tired ones brought back, and lots resurfaced — built on a proper base and crowned so the water runs off the edges.

How it goes

No mystery, no surprise invoice.

Walk the job

George comes out, looks at the ground with you and talks through what it actually needs.

A number before work starts

You get a price for the job in front of you, not a rate and a shrug.

The machine shows up

The equipment arrives when it was said it would, and the work runs start to finish.

Left clean

Ruts knocked down, ground graded, debris gone. The site is finished, not abandoned.

On the ground

Photos of his work.

Every photo here is from a real Elite Excavating job. See more recent work. Or read about the full driveway installation & repair service.

Long gravel farm lane through fields, shown from two angles
Farm drive re-based and crowned
Aerial view of a new gravel drive and turnaround at a country home
Millings compacted into a hard, dust-free surface
Finished gravel driveway between two houses
Who decides what size culvert I need?

The agency that owns the road. On county roads that is the county road agency, and on state highways it is MDOT. Ask them before buying pipe.

Can you replace a crushed culvert?

Yes. The old pipe is dug out, the new one is set at the right depth and the approach is rebuilt over it.

Can you do the culvert and the driveway together?

Yes. The approach, the culvert and the drive are normally built as one job.

Does Elite Excavating do culvert installation in Almont?

Yes. Almont is about 14 miles from the yard in Capac. George looks at the job himself, gives you a price before any work starts and runs the machine.

More around Almont

Other work he takes on.

Somewhere else? See the full service area or call (989) 702-2426.

Culvert Installation in other towns

Free estimate

Free estimate in Almont.

Send the details and he will come out, walk the job with you and give you a number before anything starts. If it is easier to talk it through, call him.

Capac, Michigan · St. Clair, Lapeer and Macomb counties

Free on-site estimate

Send it over and George calls you back.

Free estimate. A real number.

Call George. He walks the job with you and gives you a price before any work starts.

Call GeorgeFree Estimate